|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
 ;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
 ;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
 ;
good scans, all is clear. all pages in order. recommended
HP 33440/HP
33449 COMBINED
SERVICE
MANUAL
INCASE OF DIFFICULTY
If W size is incorrectly reported, repeat steps 1 through 8, checking to be sure the memory board pin connectors are fimly seated. The foUowing error messages may appew
s 53-1
@
ERRORUNITr 53-2 ERRORUNIT o Indimtes an error on a W mansion board. The number following the dash indicates which qansion board failed (1 indica~s the board in the right (front) slot 2 the lefi (rear) slot). E this error appears, now Hewleti-Packad or your authorized alder for assistance. (The user may resume printing by fiting the [-] key.)
57-1
s
ERRORUNITr 57-2 ERRORUNIT: o Indicates that more than four megabfies of =panded memory have been in~ed. The etira memo~, in one megab@ increments, in the indicated slot (1 or 2) will be ignored. but UP to four me~bms toti W be used. TO resume P~nting, . � click the (-] key.
63 SERVICEERRORH this message appears, a board maybe defective or incorrectly in&led.
s
Firm atiempt to clear the error by switching the printer off and then on again. E this does not clear the error, switch the printer OFF and check to be sure the board is seated properly. K this error @l app=s, nom Hewleti-Packard or your authorized deder for assistance.
MEMORYBOARDREMOVAL
To remove a board, first access it by repeating steps 2 through 4 in the �Ind the Boar&� section, Then unseat it (see Figure C-6) by squeezing the green tibs together w~e pfling toward you. Place the board in antistatic pack~rig.
Figure C-6. Removing Board
C-8
|
|
 |
> |
|